Troubleshooting, Symptoms Faults Solution

SECTION 7—TROUBLESHOOTING

SECTION 7— TROUBLESHOOTING

Stand-up lift feels loose.	Mast/base joint loose.	Tighten the mounting screws that secure the
		mast to the base. Refer to Assembling the Patient
		Lift on page 11.
	Tie - rods are loose.	Refer to Maintaining the Base Adjustment on
		page 34.

Casters/brakes noisy or	Fluff or debris in bearings.	Replace casters.
stiff.

Electric actuator fails to	Hand-control or actuator con-	Check connections.
lift when button is	nector loose.
pressed.
	Batteries low.	Charge batteries. Refer to Charging the Battery
		on page 19.
	RED emergency stop button	Rotate RED emergency stop button CLOCK-
	pressed IN.	WISE until it pops out.
	Battery not connected prop-	Reconnect the battery to the control box. Refer
	erly to control box.	to Charging the Battery on page 19.
	The connecting terminals are	Replace the battery pack. Refer to Charging the
	damaged.	Battery on page 19.
	Electric actuator in need of ser-	Refer to Replacing Electric Actuator on page 33.
	vice or load is too high.	Contact your Dealer.

Unusual noise from	Actuator is worn or damaged	Refer to Replacing Electric Actuator on page 33.
actuator.	or spindle is bent.	Contact your Dealer.

Lift arms will not lower	Lift arms require a minimum	Pull down slightly on the lift arms.
in uppermost position.	weight load to lower from the
	uppermost position.

NOTE: If problems are not remedied by the suggested means, please contact your dealer or Invacare.

Part No 1141431

Reliant™ 440