PROCEDURE 7 | FRONT RIGGING |
F R O N T
R
I
G G I N G
This procedure includes the following:
Installing CLD Front Rigging Release Handle
WARNING
After ANY adjustments, repair or service and BE- FORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
INSTALLING CLD FRONT RIGGING RELEASE HANDLE (FIGURE 1)
1.Remove the two (2) pan head screws, hex nut, riv nut, bushing and spring from the EXISTING front rigging release handle and retain for later use.
2.Position the bushing between the two (2) mounting holes near the tab on the CLD release handle.
3.Secure the bushing to the CLD release handle with a pan head screw and hex nut. Tighten securely.
4.Position mounting hole "A" UNDER mounting hole "B".
5.Position the hole in the spring UNDER mounting hole "A" in the orientation shown in FIGURE 1.
NOTE: The bent portion of the spring should hook over the mounting plate as indicated in FIGURE 1 and the straight end of the spring should rest inside the CLD re- lease handle and point away from the tab.
6.Secure the spring and CLD release handle to the mounting plate with the remaining pan head screw and riv nut. Tighten securely.
|
|
|
|
| Mounting Hole "B" |
| EXISTING |
|
| CLD | Pan |
| Pan |
|
|
| Head |
Existing Release | Head |
| CLD Release | Screws | |
Handle | Screws |
| Handle |
| |
|
|
|
|
| |
|
|
| Hex Nut | Tab |
|
|
|
|
|
| |
|
| Bushing |
|
|
|
|
| Mounting | Bent Portion |
| |
|
| of Spring | Straight | ||
Bushing |
| Hole "A" |
|
| |
Hex |
|
| Portion | ||
|
|
|
| ||
|
|
|
| of Spring | |
| Nut | Mounting |
|
| |
|
|
| Spring | ||
|
| Plate |
|
| |
|
|
|
|
| |
| Riv Nut | HOOK |
|
| |
| SPRING HERE |
|
| ||
Spring
Riv Nut
Front
Rigging
Front Rigging
FIGURE 1 - INSTALLING CLD FRONT RIGGING RELEASE HANDLE
22
