Invacare 9000 service manual Tools Needed, Assemblies Figure, Assembly, S E M B L Y

Wheelchairs Built BEFORE 09/05/00

ASSEMBLY			PROCEDURE 1
		Wheelchairs Built AFTER 09/05/00
This Procedure includes the following:
		1. Transmission and Wheel Lock
Assemblies
		2. Drive Arm Assembly, Support Bracket and Steering
Tools Needed			Link
		3.	Upper Drive Arm
NOTE: The procedures in this manual should be per-		4.	Fork Assembly
formed on the specific side of the wheelchair the CLD		5.	Rear Wheel Mounting Hardware
was ordered for.		TOOLS NEEDED
ASSEMBLIES (FIGURE 1)
		NOTE: Have the following tools available.
The Cyclical Lever Device (CLD) consists of several as-
		Torque Wrench
semblies shown in FIGURE 1 and described on this page.
For proper installation follow INSTALLING CLD ON EX-		7/16-inch Socket or Box Wrench
ISTING WHEELCHAIR in PROCEDURES 1-6 and per-		7/16-inch Open End Wrench
form PROCEDURE 7.		1/2-inch Socket or Box Wrench
The following five (5) items are included in each kit. Each		11/16-inch Socket or Box Wrench
		3/4-inch Socket or Box Wrench
numbered line represents a complete assembly;
		5/32 Hex Key
Wheelchairs Built BEFORE 09/05/00 -
		3/16 Hex Key
1. Hub Attachment, Transmission and Wheel Lock		No. 1 Phillips Screw Driver
2. Drive Arm Assembly, Support Bracket, and Steering		*M13 Socket or Box Wrench - Wheelchairs Built
	Link		BEFORE 09/05/00 ONLY
3.	Drive Arm	6MM Hex Key - Wheelchairs Built BEFORE 09/05/00
4.	Fork Assembly		ONLY
5. Front Rigging Release Handle		*And adjustable wrench can be used in place of the M13

wrench.

A S S E M B L Y

Drive Arm Assembly

Transmission

Drive

Arm

Support

Bracket

Wheelchairs Built AFTER 09/05/00

Drive Arm Assembly	Upper
	Drive
Transmission	Arm

Support

Bracket

Hub	Wheel Lock
Attachment
	Steering Link

Fork

NOTE: Right side final assembly shown. Assembly

Hub	Wheel Lock
Attachment
(Rear Wheel
Mounting	Steering Link
Hardware)
	Fork

NOTE: Right side final assembly shown. Assembly

FIGURE 1 - ASSEMBLIES

5