Invacare At'm manual Wheels and Casters, Replacing Front Casters

SECTION 10—WHEELS AND CASTERS

SECTION 10—WHEELS AND CASTERS

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that on/off switch on the joystick is in the off position.

DO NOT USE YOUR WHEELCHAIR UNLESS IT HAS THE PROPER TIRE PRESSURE (P.S.I.) - OTHERWISE THE WHEELCHAIR MAY NOT DRIVE CORRECTLY, STOP CORRECTLY OR MAY EXPERIENCE ERRATIC PERFORMANCE.

DO NOT overinflate the tires. Failure to follow these suggestions may cause the tire to explode and cause bodily harm. The recommended tire pressure is listed on the side wall of the tire.

Keep fingers and clothing clear of drive wheels.

CAUTION

As with any vehicle, the wheels, casters and tires should be checked periodically for cracks and wear and should be replaced.

REPLACING FRONT CASTERS

NOTE: For this procedure, refer to FIGURE 10.1.

1.Remove the mounting bolt, two (2) spacers and locknut that secures the caster to the fork.

2.Remove the caster and discard.

3.Secure new caster to fork with the existing mounting bolt, two (2) spacers and locknut. Securely tighten.

4.Repeat STEPS 1-3 for the other caster.

Wheelchair

Frame

Fork

Mounting Bolt

Locknut

Spacer

Front Caster Spacer

FIGURE 10.1 - REPLACING FRONT

CASTERS

At’m 40 Part No. 1125035