SECTION
SECTION 6—SEAT
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.
REMOVING/INSTALLING THE SEAT
NOTE: For this procedure, refer to FIGURE 6.1.
REMOVING
1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 32.
2.Remove the battery pack. Refer to Removing/Installing the Battery Pack on page 35.
3.Pull up the front seat release loop and tilt the seat back. Refer to Detail “A” of FIGURE 6.1.
4.Pull up the rear seat release cord with the other hand and lift the seat assembly off and away from the wheelchair base. Refer to Detail “B” of FIGURE 6.1.
5.Fold the seat assembly. Refer to Detail “C” of FIGURE 6.1.
INSTALLING
1. Lower the rear latches onto the rear crossbrace.
NOTE: An audible click is heard as the rear latches lock into place.
NOTE: Ensure both latches sit flush against the rear crossbrace. If not flush, lift the rear seat release cord, remove the seat and repeat STEP 1.
2.Tilt back seat assembly.
3.Unfold the seat assembly.
4.Lower the front latch onto the front cross brace until it locks in place.
NOTE: An audible click is heard as the front latch locks into place.
5.Lift the seat assembly to ensure that the seat is secured to the wheelchair base.
6.Reinstall the battery pack. Refer to Removing/Installing the Battery Pack on page 35.
7.Reconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 32.
Part No. 1125035 | 29 | At’m |
