INSTALLATION
When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See “Projection method” on page 15.
FRONT/DESK | Setting on a desk/floor and | |
projecting from front | ||
| ||
FRONT/CEILING | Mounting in the ceiling and | |
projecting from front | ||
| ||
REAR/DESK | Setting on a desk/floor and | |
projecting from rear | ||
| ||
REAR/CEILING | Mounting in the ceiling and | |
projecting from rear | ||
|
SLEEP
You can select the required duration of time and set the off timer to turn off the POWER of the projector automatically. 3 minutes before
ALTITUDE
If you use the projector at high elevations, set the fan speed to HIGH. Press I H to select HIGH or LOW.
OPTION Menu
LAMP RUNTIME
You can check how long the lamp has been used.
NOTE:
LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Care and Replacement” on page 41.
FUNCTION BUTTON
You can assign frequently used functions to each function button and access the functions instantly.
FUNCTION BUTTON
|
|
|
|
|
| FUNCTION BUTTON1 | OFF |
| |
|
|
|
|
|
| FUNCTION BUTTON2 |
|
| |
| OFF |
|
| |
|
|
|
|
|
|
|
|
|
|
| FUNCTION BUTTON3 |
|
|
|
| OFF |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1.Press F G to select the required button to assign.
2.Press ENTER.
3.Press I H to select the required function to assign.
4.Press RETURN or MENU to return to the previous menu, or press repeatedly to return to the projection.
DISABLED | SHUTTER |
NOTE:
At 1 400 m (4593 ft) above sea level, the setting must be HIGH.
LAMP POWER
You can adjust the power of the lamp to save on electricity, prolong the lamp life and reduce the noise.
HDMI2 IN
HDMI1 IN
PC IN
COMPONENT2 IN 
SHUTTER function
AUTO SETUP
VIDEO IN
COMPONENT1 IN
Settings
Options | Function | |
|
| |
NORMAL | When higher luminance is | |
required such as movies | ||
| ||
|
| |
ECO - MODE | When lower luminance is | |
sufficient such as in a small room | ||
|
NOTE:
When no input signal is detected, the function is disabled.
You can turn off the lamp and stop the projection temporary for electrical power save. Press any button except the LIGHT, DEVICE or Learning Remote control buttons to return to the projection.
NOTE:
See “Selecting the input signal” on page 21, “AUTO SETUP” on page 36.
The function buttons are also used as Learning Remote control buttons. Press the DEVICE button to switch the control mode. See “Remote Control Operating Guide” provided with the projector.
ENGLISH - 39
