Projecting an image
Selecting the input signal
1. Switch on the connected devices. | 2. Press the INPUT button to select the required |
Press the play button of the required device. | input method if needed. See "Switching the input |
| signal" on page 23. |
| The image will be projected on the screen. |
NOTE:
AUTO SEARCH is ON as default and the signal from the connected devices is detected automatically. See "AUTO SEARCH" on page 38.
Positioning the image
1.Press ASPECT to select the required aspect mode. See "Switching the aspect ratio" on page 23.
2.Adjust the projected image with the Lens shift dials. See "Lens shift and positioning" on page 16.
3. Adjust the angle of the projector.
Screw down the Front leg adjuster and adjust the angle vertically.
NOTE:
Do not touch the Air exhaust port as this may cause burns or injury.
If keystone distortion occurs, see “KEYSTONE” on page 36.
4.Adjust the focus and the projected image size.
Press +/- of the FOCUS and ZOOM buttons to adjust.
Press the LENS button to adjust the focus and zoom by Remote control. see “LENS CONTROL Menu” on page 37
Basic Operation
ENGLISH - 21
