Invacare BAR750 - page 23

SECTION 4—PACKAGING, HANDLING AND SET-UP
Part No 1143215 23 BAR750
8. Pullthehead‐endsectionfromtheshippingbracket.
9. Removetheclevispinsecuringtheshippingbrackettofoot‐endsectionfromeachside
ofthefoot‐endsection.SeeDetail“D”ofFIGURE 4.1.
10. Removeshippingbracketandtwocardboardsupportblocksfromfoot‐endbedsection.
11. Unlockthecastersonthefoot‐endsection.
12. Placepowersupplycordandhandsetontopofthebed.
13. Carefullyrollthefoot‐endsectionoffthepallet.
14. Slidehead‐endsectionintofoot‐endsectionuntilsideframeholeslineup.SeeDetail“E”
ofFIGURE 4.1.
CAUTION
Keep power supply cord and handset clear of the gap between the two sections.
15. Fromtheoutsideofthebed,insertaclevispinintoeachsideframehole.Secureclevis
pinsusingrueringsoninsideofframe.SeeDetail“F”ofFIGURE 4.1.
16. Securetheactuatorstotheframesectionusingtwosmallclevispinsandtwohairpin
clips.SeeDetail“G”ofFIGURE 4.1.
17. Usingthehandcontrol,raisethebedtoitsfullheight.
18. Removelock‐pinfromsupportleglocatedunderfoot‐endsection.
19. Pushsupportlegupandre‐insertlock‐pin.SeeDetail“H”ofFIGURE 4.1.
20. Installtheheadboardpostsintheinwardmostsocketsprovidedattheheadendwith
theboardclosesttothemattress.
21. Installthefootboardpostsintheinwardmostsocketsprovidedatthefootendwith
theboardclosesttothemattress.