MAINTENANCE | PROCEDURE 5 |
This Procedure includes the following:
Installing/Remove Back Cushion Foam
Inspection
Cleaning
REPLACING THE BACK CUSHION FOAM (FIGURE 1)
NOTE: Refer to the INSTALLATION AND STABILITY WARNINGS in the SAFETY SUMMARY of this manual.
1.Remove the back cushion from the back panels. Refer to INSTALLING/REMOVING THE BACK CUSH- IONS in PROCEDURE 2 of this manual.
2.Position the back cushion on a flat surface with the zipper facing UPWARDS.
3.Unzip the zipper.
4.Grasp the EXISTING cushion foam and remove it from the back cover.
INSPECTION
WARNING
INITIALLY AND ONCE A WEEK, visually inspect all parts, including hardware, upholstery ma- terials, foams (if accessible), and plastics for deformation, corrosion, breakage, wear and/ or compression.
Check ALL fasteners weekly to ensure that me- chanical connections are secure.
DO NOT continue to use this product if any of the conditions described above are discov- ered.
NOTE: Corrective maintenance can be performed at or arranged through your equipment supplier.
WARNING
Skinconditionshouldbecheckedveryfrequently after the installation and use of any new seat- ing system.
M A I N T E N A N C E
5. | Align the NEW cushion foam with the hole in the back | CLEANING | |||
| cover. |
|
|
| |
NOTE: Make sure the plastic insert on the NEW cushion | Cover | ||||
foam is facing the REAR of the back cover and that the | 1. Machine wash the back covers in cold water on gentle | ||||
fingers on the plastic insert face the TOP of the back | |||||
| cycle using a mild detergent ONCE A WEEK. | ||||
cover. |
|
|
| ||
| WARNING |
| |||
6. | Position the NEW cushion foam inside the back cover. |
|
| ||
| When washing the back covers - DO NOT use |
| |||
|
|
|
| ||
7. | Position the zipper inside the pouch. |
| fabric softeners or bleach. DO NOT machine |
| |
8. | Reinstall the back cushion onto the back panels. Re- |
| dry. Air dry ONLY. DO NOT dry in sun. |
| |
| Failure to follow the washing instructions CAN |
| |||
| fer to INSTALLING/REMOVING THE BACK CUSH- |
|
| ||
| IONS in PROCEDURE 2 of this manual. |
| reduce the flame retardency of the back |
| |
| Back Cover |
| cover. |
| |
|
|
|
| ||
| Foam | ||||
|
| ||||
Care should be taken to prevent the back cushion foam
from getting wet. If the back cushion foam begins to dete-
Rear of Cushionriorate from prolonged contact with moisture, it should be replaced immediately.
Zipper
Fingers
Cushion
Foam
Plastic
Insert
FIGURE 4 - REPLACING THE BACK
CUSHION FOAM
15
