Invacare Lightweight Aluminum Wheelchair manual M S, Procedure Arms, SWING-BACK Arms Figure

PROCEDURE 2 ARMS

A R M S

This Procedure Includes the Following:

Removing or Replacing Armrests

Swing-Back Arms

Replacing Armrest Pad/ Clothing Guards

WA R N I N G

After making adjustments, always make sure that parts are properly tight- ened BEFORE using the wheelchair.

REMOVING OR REPLACING ARMRESTS (FIGURE 1)

Removing Armrests

1.Unlock the arm assembly by rotating the armrest re- lease levers located on the armrest to the unlocked position.

2.Remove armrest from the wheelchair.

2.Pull the front of swing-back arm straight up/out of the arm socket and towards the rear of the wheelchair.

3.To lock the swing-back arm, push the swing-back arm towards the front of the wheelchair and then down- ward into the unlocked socket.

NOTE: Armrest release lever MUST be in the unlocked position when placing armrest into the arm sockets.

Armrest Release

Swing Back

Lever

Arm

FIGURE 2 - SWING-BACK ARMS

Replacing Armrests

NOTE: Armrest release levers MUST be in the unlocked position when placing armrests into the arm sockets.

1.Install the armrest into the arm sockets on the wheel- chair frame.

2.Lock the armrest by rotating the armrest release le- vers into locked position.

Armrest

Armrest

Release

Lever

Armrest

Arm Socket	Release
Wheelchair	Lever
	Arm
Frame
	Socket

FIGURE 1 - REMOVING OR REPLACING

ARMRESTS

SWING-BACK ARMS (FIGURE 2)

WARNING

Make sure the locking mechanism is se- cured before using the wheelchair.

1.Unlock the swing-back arms by rotating the front arm- rest release lever towards the outside of the wheel- chair.

REPLACING ARMREST PAD/ CLOTHING GUARDS (FIGURE 3)

Armrest Pad

1.Remove the phillips screws that secure the arm- rest pad to the armrest assembly.

2.Replace armrest pad and securely tighten with the existing phillips screws.

Clothing Guards

1.Remove the four (4) screws that secure the ex- isting clothing guard to the armrest assembly.

2.Replace the existing clothing guard with the new clothing guard and securely tighten with the ex- isting hardware.

3.Repeat STEPS 1-2for the opposite side if nec-

essary.

Armrest Pad

Armrest

Assembly

Screws

ClothingPhillips

GuardScrews

Screws

FIGURE 3 - REPLACING ARMREST PAD/

CLOTHING GUARDS

QUESTIONS ABOUT THIS PRODUCT?	14	CALL TOLL FREE, 1-888-6AURORA
		(628-7672)