Spirit XT685 owner manual Calibration Procedure, Adjusting The Speed Sensor, Engineering Mode Menu

Calibration Procedure

1.Remove the safety key

2.Press and hold down the Start and Fast + buttons and replace the safety key. Continue to hold the Start and Fast key until the window displays “Factory settings”, then press the Enter key.

3.You will now be able to set the display to show Metric or English settings (Miles vs. Kilometers). To do this, press the Up or Down key to show which you want, then press Enter.

4.Make sure the wheel size diameter is 3.01 then press Enter

5.Adjust the minimum speed (if needed) to 0.5 and then press Enter

6.Adjust the maximum speed (if needed) to 12.0 and then press Enter

7.Adjust the maximum elevation (if needed) to 15 and then press Enter

8.Grade return – On (This allows the incline to return to zero when Stop is pressed. For sale in Europe, EU standards require this to be off)

9.Press Start to begin calibration.The process is automatic; the speed will start up without warning, so do not stand on the belt.

Adjusting The Speed Sensor

If the calibration does not pass you may need to check the speed sensor alignment.

1.Remove the motor cover hood by loosening the 8 screws that hold it in place. Set it aside.

2.The speed sensor is located on the left side of the frame, right next to the front roller pulley (the pulley will have a belt around it that also goes to the motor).The speed sensor is a small rectangular shaped black box with a wire connected to it.

3.You will see a magnet on the outside edge of the pulley; make sure the speed sensor is aligned with the center of the magnet when it passes by. There are two a screws that hold the sensor in place that need to be loosened to adjust the sensor. Re-tighten the screws when finished.

Engineering Mode Menu

The console has built in maintenance/diagnostic software.The software will allow you to change the console settings from English to Metric and turn off the beeping of the speaker when a key is pressed for example.To enter the Engineering Mode Menu press and hold down the Start, Stop and Enter keys, then insert the safety key. Keep holding the keys down until the Message Center displays Engineering Mode Menu. Press the Enter button to access the menu below:

a.Key Test (Will allow you to test all the keys to make sure they are functioning)

b.Security (Allows the keypad to be locked to prevent unauthorized use)

c.Functions (Press Enter to access settings and Up arrow to scroll)

i.Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)

ii.Motor Test (Press Enter to run the resistance motor up and down in a continuous loop. Display shows level setting and position sensor reading. Press Stop to end test.)

iii.Beep (Turns off the speaker so no beeping sound is heard)

iv.Units (Sets the display to readout in English or Metric display measurements)

v.ODO Reset (Resets the odometer)

vi.Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)

d.LCD Test (Tests all the display functions)

XT685 Treadmill 32