Invacare 3752G, Model Removing Soap Film and Hard Water Deposits, Operating Instructions

5 OPERATING INSTRUCTIONS

8.Replace the impeller and impeller cap on each jet assembly.

￿Cross-threading the jet assembly onto the casing may cause damage to the whirlpool motor. After installation, ensure that the jet assembly is flush against the jet casing.

9.Assemble each jet assembly to the jet casings.

• Position the Sanijet® logo and RED indicator at the 11 o’clock position.

• Insert the jet assembly into the receptacle in the tub and rotate the jet assembly clockwise until it locks into place.WARNING

Removing Soap Film and Hard Water Deposits

Use a commercially available cleaner such as Invacare Heavy Duty Cleaner. Remove the jet assemblies. Remove the impeller caps. Thoroughly spray the exposed surfaces, including the jet casings. Use a long handled soft brush or similar product to wipe down all surfaces and allow the heavy duty cleaner to remain in contact with the exposed surfaces for approximately ten minutes. Rinse off surfaces using the shower wand, adjusted to spray position.

Part No. 1167458 23 Invacare® TheraPure™ Recessed Whirlpool Tubs