Invacare RPA600-1E Installing the Shifter Handle, Attaching the Battery Charger Mounting Bracket to the Wall

SECTION 2—ASSEMBLY
Part No 1078988 13 Electric Portable Patient Lift - RPA600-1E
Installing the Shifter Handle
NOTE:Forthisprocedure,referto
FIGURE 2.3.
1. Line‐uptheshifterhandlethreadswith
threadedopeninginthebase.
2. Turntheshifterhandleclockwiseand
securelytightenintothebase.
FIGURE 2.3 Installing the Shifter Handle
Attaching the Battery Charger Mounting Bracket to the
Wall
NOTE:Forthisprocedure,refertoFIGURE2.4.
1. Placethebatterychargermountingbracketonthewallatthedesiredposition.
2. Withapencil,markthemiddleholeposition.
3. Measuredown6½inchesfromthepencilmarkanddrillonemountinghole.
4. Installthebottommountingscrewuntilthereisanapproximate1/8‐inchgapbetweenthe
screwheadandthewall.
5. Putthebatterychargermountingbracketontothebottommountingscrew.
6. Drilltheothertwomountingholes.
7. Screwthemountingscrewsthroughthebatterychargermountingbracketandintothe
wall.Tightensecurely.
CAUTION
Make sure there is an audible click when mounting battery on the battery charger to
confirm proper mounting. Otherwise, injury or damage may occur.
8. Putthebatterychargerinplaceonthemountingbracket.
9. Plugthebatterychargerintoanelectricaloutlet.
NOTE:AnLEDwillilluminatewhenpowerisappliedtobatterycharger.
FIGURE 2.4 Attaching the Battery Charger Mounting Bracket to the Wall
Shifter Handle
Threads
Opening in Base
Mounting Bracket
Mounting
Screws
Bottom Mounting Screw