INSTALLATION

Mounting the Battery Charger

NOTE: For this procedure, refer to FIGURE 2.4.

NOTE: Refer to your local regulations concerning proper mounting procedures.

1.Place the battery charger with mounting bracket on the wall at the desired position.

2.With a pencil, mark the middle hole position.

3.Measure down 6½ inches from the pencil mark and drill one mounting hole.

4.Install the bottom mounting screw until there is an approximate 1/8‐inch gap between the screw head and the wall.

5.Install the battery charger with mounting bracket onto the bottom mounting screw.

6.Drill the remaining two mounting holes.

7.Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely.

8.Plug the battery charger into the wall electrical outlet.

9.Verify that On is illuminated.

Mounting Bracket

Battery Charger

 

 

with Mounting

 

Bracket

Mounting

 

Screws

 

Bottom Mounting Screw

FIGURE 2.4 Mounting the Battery Charger

Part No. 1145811

17

Stand Up Lift Model RPS350-2

Page 17
Image 17
Invacare RPS350-2 manual Mounting the Battery Charger