MAINTENANCE
Adjusting the Base
NOTE: For this procedure, refer to FIGURE 7.2.
1.Check that the legs are square when in the closed position.
2.Place a square on the inside of the legs and base to determine the 90° alignment.
3.Adjust the linkage rods until 90° alignment is achieved.
Square | Linkage Rods | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Linkage Rod
FIGURE 7.2 Adjusting the Base
Adjusting the Knee Pad Height
NOTE: For this procedure, refer to FIGURE 7.3.
1.Pick a height setting that will be comfortable to the patient and provide the necessary support.
NOTE: The knee pad should be positioned so that the knee portion of the leg contacts the pad.
2.Using both hands, pull both adjustment pins outward at the same time.
3.Position the knee pad to the desired height and release adjustment pins into the corresponding alignment holes.
4.Check to make sure that both pins are engaged.
Knee Pad
Adjustment Pin
Adjustment Pin
FIGURE 7.3 Adjusting the Knee Pad Height
Part No. 1145811 | 33 | Stand Up Lift Model |
