Invacare Topan user manual Error Codes and Diagnostic Codes

7.11Error Codes and Diagnostic Codes

FLASH	FAULT		EFFECT		Comments
CODE
1	User error or drive		Stops driving	•	Ensure that the joystick is in the neutral
	motors overloaded				central position (simply release the
					joystick) and switch on again.
				• Drive motors overloaded. Shut
					electronics down and then switch on
					again. If the driving power is still reduced,
					wait a few minutes.
2	Battery error	Stops driving		•	Check battery and supply cable.
				• Charge batteries. If you switch the
					wheelchair off for a few minutes, the
					batteries can often recharge to such an
					extent that a short run is still possible.
					However, you should only do this in an
					emergency, as this causes the batteries
				•	to discharge excessively.
					Replace batteries
3	Fault on left-hand		Stops driving	•	Check motor cable and connecting plugs.
	motor (M2)			•	Check motor.
4	Fault on right-hand		Stops driving	•	Check motor cable and connecting plugs.
	motor (M1)			•	Check motor.
5	Error on left-hand		Stops driving	•	Check cable and connecting plugs.
	(M2) wheel lock			•	Check brake.
6	Error on right-hand		Stops driving	•	Check cable and connecting plugs.
	(M1) wheel lock			•	Check brake.

42