2.1Repair or Service Information

Setup of the Electronic Control Unit is to be performed ONLY by individuals certified by Invacare. The final tuning adjustments of the controller may affect other activities of the wheelchair. Damage to the equipment could occur under these circumstances. If non-certified individuals perform any work on these units, the warranty is void.

Refer to the Spectra BlitzTM maintenance manual for detailed service and repair information

2.2General Safety Notes

GENERAL WARNINGS

Performance adjustments should only be made by professionals of the healthcare field or persons fully conversant with this process and the driver's capabilities. Incorrect settings could cause injury to the driver, bystanders, damage to the chair and to surrounding property.

After the wheelchair has been setup, check to make sure that the wheelchair performs to the specifications entered during the setup procedure. If the wheelchair does NOT perform to specifications, turn the wheelchair OFF immediately and re-enter setup specifications. Repeat this procedure until the wheelchair performs to specifications.

DO NOT climb, go up or down ramps or traverse slopes greater than 6 o.

The recommended safe slope is 6 o See page 21 - recommended driving position .

DO NOT attempt to move up or down an incline with a water, ice or oil film.

DO NOT attempt to drive over kerbs or obstacles greater than 50mm in height. Doing so may cause your wheelchair to turn over and cause bodily harm or damage to the chair.

15

Page 15
Image 15
Invacare User guide manual Repair or Service Information, General Safety Notes, General Warnings