Invacare User guide manual Unlock Function

UNLOCK Function

1.Use the power button to switch the control system on. The speed indicator will be rippling up and down.

2.Move the joystick forward until the joystick beeps, then move the joystick backward until the control system beeps.

3.Release the joystick, the control system will beep. The control system is now unlocked.

Adjusting Driving Speed

There are five pre-set speeds already programmed into the VSI control.To change speed, press the Speed Decrease button to go slower or the Speed Increase button to go faster. The current speed is indicated in the speed profile display.

Actuator Adjustment

To adjust the seat angle of your Powerchair press the actuator mode button once. The LED indicator will illuminate, move your joystick forward or backward to adjust seat angle. Once the desired seat angle has been achieved press the seat function button once to return to drive mode.

Battery Gauge

The battery gauge is used to indicate power and can also display the controller status shown in the table. It displays battery charge, fault and status information from the VSI controller. If the battery gauge shows RED, YELLOW and GREEN, the batteries are charged. If the battery gauges show just RED and YELLOW, then you should charge the batteries as soon as you can. If the battery gauge shows just RED, either steady or flashing slowly, then you should charge the batteries immediately.

84