PLACING SLIDES & NEGATIVES IN THE HOLDERS
Slides | Negatives | Negatives (Roll) |
1.Open the film holder by lifting the tab on the bottom.
2.Insert the slide(s) into the slide slot(s) or lay the negative over the negative slot.
3.Close the film holder. Be sure the latch and sides of the holder are securely in place. Only push the holder through the FILM HOLDER SLOT in the
direction of the arrow (from right to left).*
*To change move to the next picture when using the Roll Film Holder, slide the film itself through the holder (while the holder is inserted in FILM2SD's FILM HOLDER SLOT).
Note: If the image is scanned upside down or mirrored, you can also correct this by using the FLIP or MIRROR buttons later.
Tip: To avoid laying a negative in the wrong direction (which will produce a mirror image), be sure you can correctly read the serial numbers at the top of the negative when placing it in the holder.
2
