QuietPower 1800 Inverter Owner’s Manual Rev 15 OCT 01 Page 9
There are many advantages of true sine
wave over other wave forms delivered by
other inverters:
AC powered equipment is
designed to operate with true sine wave.
Many loads will perform better when
connected to the QuietPower Inverter.
motor loads start easier
reduced stress on surge
protection circuitry within the equipment
means potentially longer equipment life
Many advantages of true sine wave are
also due to the absence of the sharp-
rising edges of waveforms prevalent in
either modified sine wave or square wave
inverters. Some of these advantages are:
reduced interference in audio or electronic equipment, especially those that use less complex
internal power supplies
significantly reduced in-rush current into capacitive loads and reduced stress on t he output
devices of the inverter, potentially lengthening equipment lif e
motor loads generally operate cooler and quieter without the extra harm onic distortion generated
by a modified sine wave
4.3 Control Panel
Once the QuietPower Inverter is properly installed and connected t o batteries, it is ready to begin
delivering AC power to your loads. The control panel is the interface between you and th e inverter. This
section describes the features of this panel and is followed by other sections that cont ain inverter
operating information.
1. INVERTER 0/|: this switch turns the QuietPower Inverter ON (‘|’). It is als o used to enable or
disable POWERSAVE mode during the power-up sequence.
2. LIQUID CRYSTAL DISPLAY (LCD)
DISPLAY: displays input current from the battery and battery voltag e numerically. A multi-segment bar
graph displays actual output power in watts from the inverter when a lo ad is being operated
3. MULTI-POSITION MOUNT: the control panel is designed so it can be removed and re-attac hed
to the chassis in 90 degree increments depending on the mounting orie ntation of the inverter itself. The
panel can also be removed entirely from the unit and mounted rem otely, with the purchase of the optional
QuietPower Interface Panel.
4. FAULT CONDITION DISPLAY: should a fault occur, the error will imm ediately be displayed. An
audible alarm sounds and the back-lighting of the display will f lash to draw attention to the fault condition
(see Section 6.1)
To operate the QuietPower Inverter:
Turn the unit ON by moving the rocker switch on the control pa nel to ‘|’ position. The following
information will be displayed (upon each power-up), identifying the type and configuration of your
QuietPower:
-200
-150
-100
-50
0
50
100
150
200
0 5 10 15 20 25 30 35 40
Time (ms)
Output (volts)
169.7 V Peak
Figure 3. QuietPower Inverter True Sine Wave Output.