3.3Advanced Screen
In this section, you may set the configurations for the following items: CPU Configuration, Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP Configuration, Floppy Configuration, SuperIO Configuration, and USB Configuration.
BIOS SETUP UTILITY
Main | Advanced | H/W Monitor | Boot | Security | Exit |
Advanced Settings
WARNING : Setting wrong values in below sections may cause system to malfunction.
CPU Configuration
Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
Options for CPU
| Select Screen |
| Select Item |
Enter | Go to Sub Screen |
F1 | General Help |
F9 | Load Defaults |
F10 | Save and Exit |
ESC | Exit |
v02.54 (C) Copyright
Setting wrong values in this section may cause the system to malfunction.
3.3.1 CPU Configuration
BIOS SETUP UTILITY
Advanced
CPU Configuration
Overclock Mode | [Auto] |
CPU Frequency (MHz) | [200] |
PCIE Frequency (MHz) | [100] |
Boot Failure Guard | [Enabled] |
CPU Spread Spectrum | [Center Spread] |
PCIE Spread Spectrum | [Enabled] |
SATA Spread Spectrum | [Enabled] |
HT Spread Spectrum | [Center Spread] |
Cool' n' Quiet | [Enabled] |
Processor Maximum Multiplier | x11 |
Processor Maximum Voltage | 1.550 V |
Multiplier/Voltage Change | [Auto] |
Memory Clock | [Auto] |
Flexibility Option | [Disabled] |
Bank Interleaving | [Auto] |
Burst Length | [4 Beats] |
CAS Latency (CL) | [Auto] |
TRCD | [Auto] |
TRAS | [Auto] |
If AUTO, multiplier and voltage will be left at the rated frequency/voltage. If Manual, multiplier and voltage will be set based on User Selection in Setup.
| Select Screen |
| Select Item |
+- | Change Option |
F1 | General Help |
F9 | Load Defaults |
F10 | Save and Exit |
ESC | Exit |
v02.54 (C) Copyright
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Cnfiguration options: [Auto], [CPU, PCIE, Sync.] and [CPU, PCIE, Async.].
CPU Frequency (MHz)
Use this option to adjust CPU frequency. The range is from 140MHz to 300MHz. The default value is [200].
2 5
