Primary IDE Connector (Blue) | Secondary IDE Connector (Black) | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| PIN1 | IDE1 |
| PIN1 | IDE2 | ||||||
|
|
|
|
|
|
|
|
|
| ||
| connect the blue end |
|
|
|
| connect the black end | |||||
| to the motherboard |
|
|
|
| to the IDE devices | |||||
Note: If you use only one IDE device on this motherboard, please set the IDE device as “Master”. Please refer to the instruction of your IDE device vendor for the details. Besides, to optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and
Serial ATA II Connectors
(SATA II_1: see p.9, No. 13)
(SATA II_2: see p.9, No. 12)
SATA2
SATA1
These Serial ATA II (SATA II) connectors support SATA II or SATA hard disk for internal storage devices. The current SATA II interface allows up to 3.0 Gb/s data transfer rate.
Serial ATA (SATA) | Either end of the SATA data cable |
Data Cable | can be connected to the SATA / |
| SATAII hard disk or the SATAII |
| connector on the motherboard. |
Serial ATA (SATA)
Power Cable
(Optional) connect to the SATA HDD powerconnector
connect to the powersupply
Please connect the black end of SATA power cable to the power connector on each drive. Then connect the white end of SATA power cable to the power connector of the power supply.
USB 2.0 Header
USB_PWR | |
(see p.9 No. 17) | P+7 |
GND | |
| DUMMY |
| 1 |
| GND |
| P+6 |
| |
| USB_PWR |
HD 8CH I/O accommo-
dates 4 default USB 2.0 ports. If those USB 2.0 ports on the I/O panel are not sufficient, this USB 2.0 header is available to support 2 additional USB 2.0 ports.
1 6
