Jabra 250 Tips for Nokia Bluetooth phones, with hands-freeprofiles, English, see Fig. Fig

English

4.Leave the headset in the charging cradle for about 3 seconds, then remove the headset (see Fig. 1).

5.Unplug the AC adaptor from the charging cradle.

12 Tips for Nokia Bluetooth phones

(Such as Nokia 6310 and 8910 series)

3.Set your Bluetooth phone to “discover” the headset by following your phone’s

instruction guide. Typically, the steps involve going to a “setup”,“connect”or “Bluetooth” menu on your phone and then selecting the option to “discover” a Bluetooth device*.

4. Your phone will find the “JABRA 250” headset and ask if you want to pair with

English

Please ensure that the headset is allowed by the phone to connect without authorization. To do this, you must adjust your phone’s settings.

it. Confirm this by pressing “yes” or “ok”.

Fig. 6

Set the following menu options:

•Menu > Bluetooth > View Paired Devices > select your headset, press “Options” > Request conn. authorization? — No

13	Enhanced features (for Bluetooth phones
	with hands-free profiles)

Enhanced features are available for phones that support the hands-free Bluetooth profile such as Nokia 3600, 3650, 6310, 6310i, 8910, 8910i, Siemens S55 and S56. Check your phone’s instruction guide or contact the phone manufacturer if you are not sure if your phone supports the hands-free Bluetooth profile.

You can enable these enhanced features by using the following alternative pairing sequence.

“Pairing” to a Bluetooth phone with hands-free profile:

1. Ensure headset is off (see Turning headset on/off section).

2. Press and holdplus the volume up button until you see a solid blue light (approximately 8 seconds), then release

(see Fig. 5).

Fig. 5

5. Enter passkey or PIN = 0000 (4 zeros), then press “yes” or “ok”.

*Phone-specific pairing instructions and the most current list of phones with hands-free profile can be found online at www.jabra.com/fscs

IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly before going back to flashing every 3 seconds. If unsuccessful, the light remains solid, and you’ll need to reattempt pairing (see steps 3–5 above).

Once you’re done pairing, the following new headset features will be available:

•Last number redial (when not on a call)

While the headset is on, press and holduntil you hear 2 short beeps, release immediately.

•Rejecting an incoming call (when not on a call)

When your phone rings, press and holduntil you hear 2 short beeps, release immediately.

•Call-waiting(swapping between 2 calls)

When your phone notifies you of another incoming call while you’re on a call, press and holduntil you hear 2 short beeps, release immediately.

•Putting a call on hold

While you’re on a call, press and holduntil you hear 2 short beeps, release immediately. Repeat to retrieve the call.

10 11