2120
Optimising Audio Quality
On some phone models you may hear the echo of your own voice when you are talking.
You will then need to lower the echo level by adjusting the volume of your multi-adapter.
To adjust the echo level you need to use the stylus switch and follow these instructions:
•
Ensure the AC mains power is not plugged in.
•
Ensure the multi-adapter is in active mode.(see Answering a Call)
•
Use the stylus supplied to press and hold down the switch for more than 6 seconds
until the multi-adapter indicator light stays on constant.
•
This is similar to the pairing process,but CONTINUE to hold the stylus switch down
while the light is ON.
•
After a few more seconds you will see 1,2 or 3 longer ‘blinks’(flashes). After the
blinking stops,the standard standby mode will flash every 3 seconds.There will also
be ‘beeps/tones’in then headset – you may find it easier to listen.
•
The number of tones or flashes corresponds to the output level of the multi-adapter.
•
1 Tone / Blink High Setting
•
2 Tone / Blink Medium Setting
•
3 Tone / Blink Low Setting
Speaker Volume & Volume Control Buttons
The JABRA BT200 offers louder speaker
volume than most headsets due to its active
battery powered amplifier.You can adjust the
volume to 8 pre-set levels.Volume up (+) and
volume down (–) button will regulate the
volume to the speaker in these 8 steps. One
step per key press increases / decreases the
desired volume until a satisfactory level is
reached.An audible tone is played for each
step +/- and when either the minimum or
maximum volume has been achieved.