TOWERS AND DOORS INSTALLATION
STEP 6
Move the door assembly to the door post on water tower and slide the assembly into the door post. Locate the base of the door into the slot of serrated door positioner that positions the hinge barrel as shown.
WATER 
TOWER
GLASS DOOR
BOTTOM OF
DOOR FRAME
SHOWER BASE
HINGE BARREL
STEP 7
Check that the magnetic mouldings on door and air tower overlap. Insert adjusting bolt with locking nut into fixed nut in top cap (See below). Adjust the door with adjusting screw until the glass is parallel with shower base and door moulding mates with water tower mould- ing. It may be necessary to reposition the door into another slot (See STEP 6) which can be done without removing door from wall post. To do so remove the adjusting screw from wall post, lift the door slightly to reposition. Reinsert adjusting screw and locking nut and adjust glass door. After final adjustment, lock this posi- tion with locking nut. Repeat for other door.
DOOR POST
ADJUSTING SCREW (12mm)
LOCKING
NUT
HINGE
BARREL
STEP 8
Install cover cap by sliding over adjusting screw and bracket.
COVER CAP
11
Jacuzzi Whirlpool Bath© BY82000 03/05
