Shim Instructions, Correct | Jacuzzi BY82000 specs

BASE INSTALLATION

STEP 4

Before installing the base, make sure the 4 water supply hoses are routed to seat area. If you have a with Air unit also route the air supply hose to the seat area. If you have a with Air unit also pull the 2 flow switch cables and the control panel cable through base at this time.

With the drain fitting passing over the center of the drainpipe, lower the shower base carefully into place, push down firmly until the base is in place.

You must check the level of the base in two directions. Do not lift a corner of the shower base to level the base. This will cause a loss of contact with the mortar and void your warranty. Attach the shower base flange to the stud wall and blocking with self-drilling screws (included). Use a minimum of 3 screws per flange section.

	FLOW
CONTROL	SWITCH
PANEL	CABLE*
CABLE*	(2X)
POSITION BASE OVER CENTER OF
DRAIN PIPE AND SET INTO PLACE
* ONLY WITH AIR TOWER UNITS

STEP 5

Before installing the seat frame, apply silicone sealant around mating flange on base. Lower seat frame onto flange and base. Attach the seat frame flange to the stud wall and blocking with self-drilling screws (included). Use a minimum of 3 screws per flange section. Clean up any excess sealant.

BLOCKING

SEAT

FRAME

APPLY

SEALANT

FLANGE

LOWER SEAT FRAME OVER

FLANGE ON BASE

NOTE: If there is any gap between seat frame flange and stud or blocking, shims MUST be used to pre- vent distortion or cracking of the flange. See Shim Instructions.

STEP 6

With a large screwdriver and the tool included with the drain, tighten the inside compression nut to seal the drain pipe connection. After drain is fully installed, test for proper drainage. If the shower base does not drain properly, rectify this condition before proceeding with the installation. Jacuzzi Whirlpool Bath© is not re- sponsible for removal and/ or reinstallation costs.

NOTE: If there is any gap between base flange and stud or blocking, shims MUST be used to prevent distortion or cracking of the flange. See Shim In- structions.