Assemble and Install the Shower Tower
1.Attach the shower arm and prepare the glass shampoo platform as follows.
a.Attach the shower arm (4) to the front plate (1) with screw nut (11), see Figure 4. Confirm the screen washer at the water inlet fitting of the wall mount shower head (3) is in place and screw the shower head onto the shower arm by hand. Finally, place a sealing washer (21) into the end connector of the flexible tubing as shown in the Figure, and fasten the tubing connector to the shower arm.
b.Prepare the glass shampoo platform (14) for as- sembly to the front plate (1), see Figure 5. Insert the rings (27) and rubber washer (24) into the threaded end of the pillar of the glass shampoo platform (14).
Figure 4
41
11
3
1 21
c.Attach the glass shampoo platform (14) onto the front plate using the washer plates (25), spring washers (24), and brass nuts (23) to fasten the assembly.
d.Place a sealing washer (21) into the hexagon nut of the S.S. flexible hose (16), then, attach the hose onto the threaded connector (22) at the bottom of the back housing (5), see Figure 6.
NOTE: There are five sealing washers (21). One is for use in the hexagon nut of the S.S. flexible hose, another is used for the hand shower. The remaining three sealing washers are spare parts to be stored for later use.
NOTE: Flush the water lines supply lines to eliminate any construction debris prior to connecting water lines. Ensure there is no particle contamination on the threaded ends of the water supply pipe. Debris and particles in the water supply will reduce shower performance.
Parts List
The parts list table common to all Ristorre shower towers is located on Page 9. Please refer to this table for com- ponent identification of parts list in all Ristorre shower towers.
Figure 5
14 | 27 | 26 |
| |
25 | 23 | |||
|
| |||
|
|
|
Mirror Installation
8
24
Figure 6
21
5
22
2216
Cover 
6
9
Jacuzzi Whirlpool Bath: Shower Towers | Page 11 | FZ71000C • 10/07 |
