2.Connect 1/2" hoses from the front plate (1) marked in red and blue to the hot and cold water supply’s, respectively, as shown in Figure 7.
COLD WATER
NOTE: Do not bend or kink the hoses when installing. Tighten fittings with a wrench and test for leaks.
3.Align the three mounting holes of the back housing (5) and front plate (1) with the three mounting rods (7) on wall. Fasten the front plate to the fixing rods and attach with the washers (9) and cap screws (10) provided.
NOTE: Figure 8 shows the hot and cold supply locations.
Figure 7
RED AND BLUE WATER SUPPLY LINES
SUPPLY
HOT WATER
SUPPLY
(1/2" NPT
Thread)
BLUE HOSE
RED HOSE
5 | 7 | 10 | 9 | 5 | 7 |
|
|
9
10
7
Ovale | Onda | Metallo |
Figure 8 | Place supply lines | Place supply lines | Place supply |
| lines | ||
| within hatched region | within hatched region | |
| within hatched | ||
|
|
| |
|
|
| region |
6.25" | 6.25" | 2.00" | 2.00" |
|
| 6.25" |
|
11.00" | 3.50" | |
18.50" | ||
|
Jacuzzi Whirlpool Bath: Shower Towers | Page 12 | FZ71000C • 10/07 |
