Jacuzzi F258000 manual Placing Tower

PLACING TOWER

CAULK

SET BACK 13/32"

R SCREW

QTY.-3

ILLUSTRATION 11

M4.2X19MM

STAINLESS STEEL

7.Dry fit tower pins into holes to check hole location. Apply sealant around the three tower wall holes on the bath and around the perimeter where the tower will sit. (See Illustration 11.)

8.Place the tower pins in the holes and push the tower down firmly. The tower will stand temporarily on its own. Clean off excess sealant.

9.Place the U-extrusion against the wall edge, set back 13/32" from front edge. Drill three (3) 1/8" holes into the wall and U-extrusion. Put sealant on the mating surface of the U-extrusion, or on the wall, and secure the U-extrusion to the wall with the stainless steel screws, R.

12