FIXED PANEL ASSEMBLE TO BATH
CAULK
AA
VERTICAL EDGE OF TOWER
GENTLY PUSH |
|
THIS AREA | (5) P |
(4) R
| 2 | 1 | |
4 | 3 | FASTENING | |
SEQUENCE | |||
| |||
|
| T | |
| 5 |
|
ILLUSTRATION 15
LOCATED IN HARDWARE KIT
T | NUT | HEX LOCKNUT | R SCREW | |
| ||||
|
| |||
|
|
| ||
P WASHER | FLAT WASHER | AA SCREW | ||
#8 TYPE B | ||||
| STAINLESS STEEL |
M4.2X19MM
STAINLESS STEEL
SET SCREW
11.Screw 1 1/2" Allen set screw 3/4" deep into the bottom of the fixed panel. Lay a 1/4" bead of sealant under the bottom rail and inside the back channel of the vertical frame. Place the assembly against the vertical edge of the tower and onto the bath surface, interlocking the two extrusions. (See Illustration 15.) Secure the assembly to the bathtub using one (1) nut and washer and four (4) screws and washers following the fasten- ing sequence. Gently push on the shaded portion of the bottom rail (see Illustration 15) to align with the holes in the bath shell. After installing the fixed panel, apply sealant along all four inside edges of the glass frame. Clean up excess sealant.
14