RING TOP PLANE MARK
STUD WALL | |
MARK LINE TOP PLANE | |
| OF RING |
| TOP RING |
WALL | TOWER |
BRACKET | WALL |
ILLUSTRATION 17
BRACKET TO WALL
MARK LINE |
|
WALL BRACKET |
|
RING |
|
INNER SURFACE OF | |
BRACKET UPPER LEG | |
SCREW (3) W |
|
WASHERS(3) | V |
12.Locate the top ring. Remove the plastic retainer extrusion and set it aside for later use. Place the top ring on the fixed panel and tower wall. The top ring groove on the underside of the top ring must mate with the top of the fixed panel. The flat portion of the ring should be parallel with the stud wall. (See Illustration 16.) Mark a line on the stud wall indicating the top plane of the bracket. (See Illustration 17.) Remove the ring. The top surface of the bracket upper leg must align with the top ring line previously marked. (See Illustration 18.) Locate and secure the bracket to the wall.
13.Place the top ring on the tower and fixed panel. Align the three holes in the top ring with the two tower holes and one hole in the fixed panel. (See Illustration 19.) Secure the top ring to the tower.
BRACKET LOCATING
PARALLEL |
WITH |
STUD WALL |
FLAT PORTION |
OF TOP RING |
ILLUSTRATION 16
LOCATED IN HARDWARE PACK
| FLAT WASHER |
U WASHER | TYPE A |
STAINLESS STEEL |
VSCREW WOOD SCREW
TOWER WALL |
ILLUSTRATION 18
RING TO TOWER
WBOLT
XSCREW
YWASHER
SCREW, HEX WASHER BOLT
SHEET METAL SCREW
EXTERNAL TOOTH
STAINLESS STEEL
SCREW HERE | SCREW(1) X WASHER (1) Y | SCREWS (2) W |
SCREW INTO
FIXED PANEL
ILLUSTRATION 19 | 15 |
|