DRILLING TOP RING
OUTSID
E
15°
IMPORTANT:
MUST DRILL AT A 15°
1/8" ANGLE TO AVOID DRILLING THROUGH ROLLER TRACK OF TOP RING.
14.Drill a 3/32" diameter hole into the top ring at a 15° angle. (See Illustration 20.) Engage the top of the fixed panel with the top ring groove. Secure the top of the fixed panel to the top ring. (See Illustration 21.)
ILLUSTRATION 20
DRILLING TOP RING
ROLLER FIXED
TRACK PANEL
TOP RING
GROOVE
15°
IMPORTANT: S MUST DRILL AT A 15°
ANGLE TO AVOID DRILLING THROUGH ROLLER TRACK.
ILLUSTRATION 21
RING TO BRACKET
PAINT OUTSIDE EDGE TO
MATCH BATHROOM FINISH
BOLT W
ILLUSTRATION 22A
S SCREW | M3.5X9.5MM |
STAINLESS STEEL | |
|
15.Plumb and square the tower. (See Illustrations 22A and 22B.) Secure the top ring to the wall bracket by inserting the hex bolts through the wall bracket into the top ring and tighten (wall bracket is
LOCATED IN HARDWARE PACK
W BOLT | SCREW, HEX | |
WASHER BOLT | ||
|
RING TO BRACKET
ILLUSTRATION 22B
16