OPERATING INSTRUCTIONS
Operation
NOTE: These instructions pertain to all Builder/Comfort bath products manufactured by Jacuzzi Whirlpool Bath. Not all features discussed in this instruction booklet apply to all baths.
All baths manufactured by Jacuzzi Whirlpool Bath are designed for "fill and drain," which means the bath should be drained after each use and filled with fresh water by the next bather. This is a health precaution, as these baths are not designed to hold water continuously like pools or spas. If you want a unit designed to continuously hold water, see your Jacuzzi Whirlpool Bath dealer for the complete line of whirlpool spas available.
Once the bath is installed, remove any residue or foreign materials left over from construction. Paint, tar, or other difficult surface stains can be removed with paint thinner, turpentine, or isopropyl alcohol (rubbing alcohol). NOTE: Use these chemicals only on SURFACE stains. Other dirt can be cleaned off with a mild liquid detergent on a damp cloth. Scrape off plaster with a wooden or plastic edge; do not use metal scrapers,
wire brushes or other metal tools, as they will damage the bath's surface.
Water Level
Close the drain and fill the bath until water is at least 1" to 2" (25,4 mm - 50,8 mm) above the highest jet (see water line indicated in the illustration). Do not turn on the whirlpool system at any time if the jets are not completely immersed in water. Do not immerse the control panel by overfilling the bath. Running the whirlpool system when there is insufficient water in the bath could result in water spraying outside the bath area. Running the whirlpool system without water will damage the recirculating pump.
IMPORTANT: When exiting the bath, the water level will drop below the jets which could result in water being sprayed out of the unit. To prevent this, you must turn unit off before exiting bath.
Jacuzzi builder/comfort units come equipped with electronic con- trols. Refer to the Electronic Controls instructions on the next page.
ENGLISH
FILL TO AT LEAST
1" - 2" (25,4 mm - 50,8 mm)
ABOVE HIGHEST JET
(Optional) RapidHeatTM
Operation
TYPICAL BATH FITTINGS
ELECTRONIC |
CONTROL |
SWITCH |
FULLY ADJUSTABLE JETS |
SUCTION |
COVER |
WATER RAINBOW |
FILL SPOUT (OPTIONAL) |
DRAIN/OVERFLOW |
(OPTIONAL) |
Once the heater is installed and the whirlpool pump is operating, | Export units come equipped with the Magic Touch® Whirlpool ON/ |
the heating function is totally automatic. The heater will help main- | OFF switch. Refer to the Magic Touch® Whirlpool Switch instructions |
tain the temperature of the water in the bath. | on the next page. |
|
Vacuum or Pressure Switch
The heater is equipped with a preset vacuum switch or pressure switch which will not allow the heater to turn ON if the pump is not running with water flowing through the whirlpool system.
High-Limit Switch
The heater includes an exclusive
HIGH LIMIT RESET | HEATER ON |
OVER HEAT | HEATER ON |
| |
PROTECTION |
|
PUSH TO RESET |
|
TYPICAL BATH FITTINGS
MAGIC TOUCH WHIRLPOOL |
ON/OFF SWITCH |
AIR CONTROL |
KNOBS |
FULLY ADJUSTABLE JETS |
SUCTION |
COVER |
WATER RAINBOW |
FILL SPOUT (OPTIONAL) |
DRAIN/OVERFLOW |
(OPTIONAL) |
25
Jacuzzi Whirlpool Bath K272000AF 7/06
