OPERATION
Air Bath Control Operation
Indicator light
Air Bath Controls
Normal Mode
Press this button to turn the blower on. The Indicator light will come on. The blower will turn on for 20 minutes at a constant intensity. The intensity may be changed by using either the Up Arrow button or the Down Arrow button.
Pressing this button a second time will turn the blower off. The control will automatically remember the last mode used. When the blower is turned off, the Indicator light will go off and the blower will continue to run for 10 to 15 seconds to allow the heater element to cool.
Wave Mode
Press this button to change the blower’s power from a minimum to a
Pulse Mode
Press this button to change the blower’s power rapidly from the minimum to a
Toggle Switches
In the Normal mode with the blower power constant, press the Up arrow to increase or the Down arrow to decrease. In the Wave or Pulse mode, these buttons change the blower’s intensity to a
Cleaning the Bath | ENGLISH |
| |
To clean your bath, simply use a mild, nonabrasive liquid |
|
detergent solution. You can protect and restore the gloss to a |
|
dulled acrylic surface by applying Meguiar’s #10 Mirror Glaze, |
|
a product specifically designed for use on acrylic finishes. If |
|
Meguiar’s is not available, an acrylic polish of equal quality or |
|
automotive paste wax is acceptable. |
|
Never use abrasive household cleaners on any Jacuzzi© |
|
Whirlpool Bath product. |
|
Repairs to the Surface
Major scratches and gouges which penetrate the acrylic surface will require refinishing. Ask your Jacuzzi© Whirlpool Bath dealer for special instructions.
PrO3 ozone sanitation system
The unit has a PrO3 Ozone Sanitation System installed. The ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for 20 minutes, and then it will automatically shut off. Thereafter, every 4 hours, the ozone will operate for 20 minutes automatically and continuously.
NOTE: A soft noise is produced by the pump during operation of the equipment.
To Set Ozone Timer
Determine the best time for the ozone generator to operate. The ozone generator should be programmed to operate when the air bath is not in use. Six hours before use, interrupt the power to the air bath at the dedicated GFCI circuit breaker. Be sure to observe all safety precautions. When the dedicated GFCI circuit comes back on, the system is activated and the ozone timer is set to begin a regular cycle as scheduled.
CAUTION: In the event of a power outage, the timer period will need to be reset.
Jacuzzi© Whirlpool Bath: Installation and Operation | Page 13 | BE76000F • December 2007 |
