PrO3 Ozone Sanitation System
The unit has a PrO3 Ozone Sanitation System installed. The ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for 30 minutes, and then it will automatically shut off. Thereafter, every 4 hours, the ozone will operate for about 20 minutes.
NOTE: A soft noise is produced by the pump during operation of the equipment.
Plumbing
All Luxury Series baths are factory tested for proper operation and watertight connections prior to shipping. If leaks are detected, notify your dealer immediately. Do not install the unit.
Water Supply
Consult local authorities for plumbing code requirements in your area.
IMPORTANT: Proper installation of the fill spout plumbing and compliance with local codes are the responsibility of the installer. Jacuzzi© Whirlpool Bath does not warrant connections of water supply fittings and piping, fill systems, or drain/overflow systems. Nor is it responsible for damage to the bath which occurs during installation.
CAUTION: A nonflammable protective barrier must be placed between soldering work and bath unit to prevent damage to the bath.
Clean-Up After Installation
The acrylic finish will give
Remove spilled plaster with a wood or plastic edge. Metal tools will scratch the surface. Spots left by plaster or grout can be removed if lightly rubbed with a mild detergent and a damp cloth or sponge.
Minor scratches that do not penetrate the color finish can be removed by lightly sanding the surface with a
Major scratches and gouges that penetrate the acrylic surface may require refinishing. Ask your Jacuzzi® Whirlpool Bath dealer
ENGLISH
Jacuzzi© Whirlpool Bath: Installation and Operation | Page 12 | BE76000F • December 2007 |
