Jacuzzi SEDONA manual Specifications, Total Weight Product Dimensions Floor Loading Electrical

Models: SEDONA

1 20
Download 20 pages 50.88 Kb
Page 4
Image 4

Important: Read complete instructions before beginning installation.

Each shower base is shipped with a drain and stainless steel strainer

Remove the shower base from the carton. Do not destroy the shipping carton until after satisfactory inspection of the product.

Immediately upon receipt, inspect the base before installing. Should inspection reveal any damage or defect in the finish, do not install the base. Damage or defect to the finish claimed after the base is installed is excluded from the warranty. Jacuzzi Whirlpool Bath’s responsibility for shipping damage ceases upon delivery of the products in good order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information packaged with the product. Jacuzzi Whirlpool Bath is not responsible for any defect that could have been discovered, repaired, or avoided by following this inspection and testing procedure.

Plan the installation in relation to the finished wall surfaces. Take into account the dimensions of both the shower base and the shower door enclosure to be used with it.

NOTE: Damage or defects which could have been discovered and repaired prior to installation and which are claimed after final installation of the product are excluded from our warranty.

SPECIFICATIONS

 

 

TOTAL WEIGHT/

PRODUCT

 

DIMENSIONS

FLOOR LOADING

WEIGHT

ELECTRICAL

 

 

 

 

 

60"

(1524 mm) L

310 lbs

110 lb

*230 VAC, 60 Hz.

32"

( 813 mm) W

(141 kg)

(50 kg)

40 AMP, 3 Wire

18-5/8"

( 473 mm) H

/23 lb/sq. ft.

 

Requires a

 

 

(112 kg/sq. m)

 

Dedicated Separate

 

 

 

 

Circuit.

 

 

 

 

 

*SteamPro supplied with NEMA 6-50P plug. NEMA 6-50R receptacle required.

Product specifications are subject to change without notice.

LOCATION FOR INCOMING WATER SUPPLY LINE TO STEAMER (INSTALLED AND PREPLUMBED WITH 3/8" COPPER TUBINGTO STEAM GENERATOR WITH SHUT OFF VALVE)

60"

16-5/8"

8-1/2"

45-3/8"

TOP VIEW

RECEPTACLE LOCATION (RECEPTACLE TO BE ACCESSIBLE FROM

32" SERVICE ACCESS)

STEAM

GENERATOR

SHUT OFF

VALVE

1" TILE FLANGE

18-5/8"

STEAM HEAD AND SHIELD

 

 

( PRE-INSTALLED AND

 

 

CONNECTED TO

 

 

STEAM GENERATOR)

 

SERVICE

 

(LEFT HAND UNIT SHOWN)

ACCESS

 

 

 

SIDE VIEW

 

2

Page 4
Image 4
Jacuzzi SEDONA manual Specifications, Total Weight Product Dimensions Floor Loading Electrical