Jacuzzi U961000G Water Level, Magic Touch® Whirlpool Switch, OPERATION, MAGIC TOUCH SWITCH, TYPICAL BATH FITTINGS

OPERATION

All baths manufactured by Jacuzzi Whirlpool Bath are designed for "fill and drain," which means the bath should be drained after each use and filled with fresh water by the next bather. This is a health precaution, as these baths are not designed to hold water continuously like pools or spas. If you want a unit designed to continuously hold water, see your Jacuzzi Whirlpool Bath dealer for the complete line of whirlpool spas available.

Once the bath is installed, remove any residue or foreign materials left over from construction. Use turpentine or paint thinner to remove stubborn stains, paint or tar. Other dirt can be cleaned off with a mild liquid detergent on a damp cloth. Scrape off plaster with a wooden or plastic edge; do not use metal scrapers, wire brushes or other metal tools, as they will damage the bath's surface.

Water Level

Close the drain and fill the bath until water is at least 1" (25 mm) above the highest jet (see water line indicated in the illustration). Do not turn on the whirlpool system at any time if the jets are not completely immersed in water. Running the whirlpool system when there is insufficient water in the bath could result in water spraying outside the bath area. Running the whirlpool system without water will damage the recirculating pump.

FILL TO AT LEAST

1" ABOVE HIGHEST JET

TYPICAL BATH FITTINGS

MAGIC TOUCH®
WHIRLPOOL	AIR
ON/OFF SWITCH	CONTROL
	KNOBS (2)
FULLY ADJUSTABLE JETS
SUCTION
COVER

DRAIN/OVERFLOW

Magic Touch® Whirlpool Switch

The Magic Touch whirlpool ON/OFF switch, conveniently located on the bath, allows you to turn the whirlpool system on and off while in the bath. Simply push down on the switch button to turn on the whirlpool sys- tem. To turn the system off, push down on the button again.

If your bath has an optional Jacuzzi Whirlpool Bath wall mounted timer, set it for the amount of time you wish the whirlpool to operate. NOTE: when you desire less than 10 minutes of whirlpool action, it is necessary to turn the timer knob clockwise past the number 10 and then back to the desired amount. If the whirlpool action does not begin when the timer is correctly set, it is necessary to push the Magic Touch switch button.

MAGIC TOUCH SWITCH

			L	P
		R		P
	I			O
W	H			O
W				L
				L

PUSH

ON/OFF

ENGLISH

DEPRESS CENTER ON/OFF