JAI CV-M10 operation manual Jumper settings

CV-M10BX/CV-M10RS

8. Jumper settings

Switch off the power before making any mode or jumper settings.

The following modes are available with jumper setting:

Input/Output Mode of HD/VD signal. (HD/VD input is factory setting)

Termination of HD/VD input. (75 ohm is factory setting.)

Trigger input termination. (Factory setting is TTL)

Trigger mode select. (Edge Pre-select is factory setting)

H-reset or H non-reset. (Fatory setting is H reset.)

Alternative pins for inputs/outputs.

￿￿	31￿	￿	Int.HDinputFunction75ohm￿￿term.￿		InputOpen75ohm￿	HVandInputShortVDTTLsignals￿￿ ￿￿		OutputShort	Remarks
	4		Ext. input75ohmterm.￿		Short	Short		Open
Jumper6						Open￿
￿	JP7￿5		Int.VDoutput￿		Open￿			Short	Remarks
Jumper￿￿JP10￿￿				Function￿￿	TTLOpeninput￿￿	Triggerinput￿￿
			Triggerinputtermination￿				75ohmShortterminated
8.2. Trigger input				ation
	on PK8206A for BX or PK8190A for RS.

settings in "italic bold" are factory setting.

8.1. HD/VD signals Jumpers on PK8189A.

￿JumperJP13￿	Function￿￿			H-resetEdge￿		PreRandom-selectHnon-resetTrigger￿	ShutterHPulseModeWidth￿￿ControlHnon-*)est		Remarks
	Hreset/non-reset￿				Open￿	ShortOpen￿	Openreset￿	Short
2￿	Triggmodeselect￿						Short￿
8.3. Trigger mode s			ion
Jumpers on PK8206A for BX or PK8190A for RS.
*) Note: For	ulse Width C	trol, shutter speed must be s t to 1/10,000 sec. (For BX by SW1. For RS by RS232C)
￿￿￿R2019￿￿	PxelVideoclock2outoutononpinpin#9#9￿				VideoShortOpen2￿￿		PixelShortOpenclock
8.4. Pixel clock or video 2 on pin 9 (12 pin con.)

Jumpers on PK8187A.

8.5. Alternative input/outputs on pin #6 and #7 (12 pin con.)

￿Jumpers￿JumperR2761￿￿on WENTriggerPK8187A￿￿. Function￿ HDOpenin/outSignal-￿￿￿onpinTriggerinShort#6-￿￿￿ VDOpenin/out-￿￿￿SignalTriggShortOpon-enpin￿￿￿#7￿WENShortOpen-out Remarks

- 11 -