8.6. Locations of Jumper
Jumpers positions are shorted with a 0 ohm resistor or by a soldering between the 2 points. To remove the solder tin from a jumper position, use a special tin remover such as desolder wick.
8.6.1. Location of Jumper on PK8189A
On this board the jumpers for HD/VD input, output and 75ohm termination are found.
JP6 JP4JP5
JP3 | JP1 JP7 |
8.6.2. Location of Jumper on PK8187A
On this board the jumpers for alternative outputs on the 12 pin connector are found.
R21 |
R27 |
R26 |
R20 |
R19 |
- 12 -
