JAI CV-M30 operation manual Table of Contents

CV-M30
Table of Contents
1. General	2
2. Standard Composition	2
3. Main Features	2
4. Locations and Functions	3
5. Pin Assignment	4
5.1. 12-pinMulti-connector(DC-IN/VIDEO OUT, EXT.HD/VD IN)	4
5.2. 6-pinMulti-connector (TRIGGER)	4
5.3. Input and Output Diagram	5
6. Functions and Operations	6
6.1. Input of External HD/VD Signals	6
6.2. Continuous Operation	6
6.3. External Trigger Mode	6
6.3.1. Edge Pre-select Mode	7
6.3.2. Pulse Width Control Mode	8
6.4. Other Functions	9
6.4.1. Double Speed Mode	9
6.4.2. Partial Scanning Mode	9
6.5. Timing Charts	9
6.5.2. External Sync Mode	10
6.5.3. External Sync Mode. Partial Scan	10
6.5.4. Edge Pre-select	11
6.5.5. Edge Pre-select. Partial Scan	11
6.5.6. Pulse Width Control	12
6.5.7. Pulse Width. Partial Scan	12
7. Mode Setting	13
7.1. Switch SW1 on Rear Panel	13
7.1.1. SW1 Lay-out	13
7.1.2. Table for SW1 Setting	13
7.1.3. Table for Shutter Time	13
7.1.4. Scan Mode Settings	14
7.1.5. Double Speed Mode	14
7.1.6. Trigger Mode	14
7.1.7. Gain Setting Switch	14
7.2. Internal Switch and Jumper Settings	15
7.2.1. Trigger/VD and HD Termination	15
7.2.2. Trigger Mode Select	15
7.2.3. Gamma Select	15
7.2.4. Internal Switch Positions	15
7.2.5. Internal Jumper Positions	15
8. Internal Adjustments of Video Signal	16
9. External Appearance and Dimensions	17
10. Specifications	18
10.1. Specification table	18
10.2. Spectral Sensitivity	18
11. Appendix	19
11.1. Precautions	19
11.2. Typical CCD Characteristics	19
12. Users Record	20

- 1 -