Manuals / JAI / Photography / Security Camera

JAI CV-M30 Internal Adjustments of Video Signal, VR4 is for factory adjustment only. Do not touch

Models: CV-M30

1 21

Download 21 pages 56.07 Kb

Page 17

Image 17

CV-M30

8. Internal Adjustments of Video Signal

For adjustment of the video output signal there are internal potentiometers on th PK 7987A board.

Adjustment should only be done in a setup with a standard test chart and controlled illumination Do not touch these potentiometers unless you are familiar with camera adjustments.

VR 1 is for AGC level setting. Factory setting is 700 mVpp ±30 mV

VR2 is for black level set-up. Factory setting is 20 mVpp ±2 mV

VR3 is for white clip level. Factory setting is 800 mVpp ±30 mV

VR4 is for factory adjustment only. Do not touch!

Fig. 21. Internal adjustments positions

- 16 -

Page 17

Image 17

JAI CV-M30 operation manual Internal Adjustments of Video Signal, VR4 is for factory adjustment only. Do not touch

Contents

Operation Manual CV-M30Monochrome Double Speed Camera Camera Revision DCV-M30 Table of Contents2. Standard Composition 3. Main FeaturesCV-M30 1. GeneralCV-M30 4. Locations and Functions5.2. 6-pin Multi-connector TRIGGER 5.1. 12-pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VD INSignal 5. Pin AssignmentFig. 4. WEN and EEN output Fig. 5. HD and VD/Trigger input 5.3. Input and Output DiagramCV-M30 6. Functions and Operations 6.1. Input of External HD/VD Signals6.2. Continuous Operation 6.3. External Trigger ModeCV-M30 6.3.1. Edge Pre-select ModeCautions in the Edge Pre-select Mode CV-M30 6.3.2. Pulse Width Control ModeCautions in the Pulse Width Control Mode 6.4. Other Functions 6.5. Timing Charts6.4.1. Double Speed Mode 6.4.2. Partial Scanning Mode6.5.3. External Sync Mode. Partial Scan 6.5.2. External Sync ModeCV-M30 H = 31.778 µs6.5.5. Edge Pre-select. Partial Scan 6.5.4. Edge Pre-selectCV-M30 H = 31.778 µs6.5.7. Pulse Width. Partial Scan 6.5.6. Pulse Width ControlCV-M30 H = 31.778 µs7.1. Switch SW1 on Rear Panel 7. Mode Setting7.1.2. Table for SW1 Setting Mode setting7.1.7. Gain Setting Switch 7.1.4. Scan Mode Settings7.1.5. Double Speed Mode 7.1.6. Trigger Mode7.2.4. Internal Switch Positions 7.2. Internal Switch and Jumper Settings7.2.1. Trigger/VD and HD Termination 7.2.2. Trigger Mode SelectCV-M30 8. Internal Adjustments of Video SignalVR4 is for factory adjustment only. Do not touch Fig. 22. Outline 9. External Appearance and DimensionsCV-M30 10.1. Specification table 10. Specifications10.2. Spectral Sensitivity CV-M3011.2. Typical CCD Characteristics 11.1. Precautions11. Appendix V. Smear12. Users Record Users Mode Settings Users ModificationsCamera type CV-M30