10
Channel Selection Switch
2 |
1 |
The camera will be set to channel 1 from the factory. To change the camera to channel 2, you will need to remove the sun shield and unscrew the lens cover. Locate the channel selector. Slide the switch to channel 2 and screw on the lens cover back on until it’s snug. Each camera must be assigned to a specific channel; both cameras cannot be on the same channel or the signals will cancel out. If using only one camera you can select either Ch 1 or Ch 2, whichever provides the best picture. The slide switch located on the rear of the Receiver must be set to reflect the channels in use. Set the receiver to Ch 1, Ch 2, or Ch 1/2. See further instructions in the receiver section (page 7).
