15
-3/16" drill bit (for drilling holes, if using plastic anchors to mount onto drywall or brick material)
-Screwdriver
-Adjustment wrench (included)
Step 1. Mounting preparation Once a suitable location for the camera has been selected and
the cable route has been determined, you will need to use the camera’s mounting bracket as a template to mark holes for drilling. Mark three holes on the
wall for the anchors or screws as shown. Please take care to mark the center of the holes.
Note: Before mounting camera permanently, check to ensure the appropriate channel has been selected (see Channel Selection) to provide good reception at the receiver/monitor.
Step 2. Cable routing -IMPORTANT
(a)If running the cable along the wall surface, position cable through slot at base of mounting bracket before installing mounting bracket (see figure A).
