20
Blank monitor
1.Make sure receiver or monitor is switched ON. Ensure the correct video input on the TV/monitor has been selected.
2.Make sure video cable is connected to TV/monitor.
Interference on camera picture
1.Make sure each camera (transmitter) is within range, and that no large obstructions are blocking the signal.
2.Try repositioning the camera, receiver or both
to different locations in order to improve the reception quality.
3.If using two cameras, make sure the cameras are not set to the same channel.
4.Reposition other nearby equipment transmitting on the 900MHz frequency.
5.Adjust the antenna for the camera, receiver or both to obtain best image.
The image is upside down
You may have to rotate the camera housing. Loosen the hex head nut and rotate housing so that the channel selection switch is above the lens (see page 17).
Audio problems
1.Ensure the volume is turned up sufficiently on the Monitor (or TV).
