JBL SG3030, SG2020 manual Connections cont, Setting the Clock, Headphones, Antenna, Getting Started

GETTING STARTED

Connections (cont.)

Setting the Clock

Headphones

Connecting a headphone 32 automatically dis- ables the loudspeakers in order to provide a pri- vate listening session.

Antenna

Important

FM Antenna Connection

Unless radio signals are very weak, no external antenna is necessary. Simply connect the sup- plied FM indoor antenna wire to the terminal marked FM on the back of the unit 44 .

AM Antenna Connection

Connect the supplied AM loop antenna to the terminal marked AM on the back of the unit 44 .

Setting the clock will be demonstrated with the example of 9:25 AM.

Although JBL Soundgear will retain the clock setting when you power it down into the Standby mode, the setting will be lost if the unit is unplugged or the electrical power is interrupted for more than 10 seconds. In that event, the clock setting will be erased, and JBL Soundgear will display a blinking “— : —“.

When setting the time, remember that midnight is at 12:00 AM and noon is at 12:00 PM.

1. Press the Clock button ª. (If the clock was

previously set, press and hold the Clock button

for more than 1.5 seconds.)

5.Press the Set/Station button °.

6.Set the minute by pressing the Preset Up c or the Preset Down g buttons.

7.Press the Set/Station button °, and the clock will resume normal operation.

FM external antenna (not supplied)

75 ohms coaxial cable

FM indoor

antennaAM

Position
it for the	GND
best	FM
reception

AM loop antenna (included)

“12:00 AM” will blink in the Display c, to

indicate civilian 12-hour time. Press the Preset

Up c or Preset Down g button to display a

blinking “0:00”, which denotes 24-hour military

time.

2. Choose between the 24-hour display or 12-

hour display by pressing the Preset Up c or

the Preset Down g buttons.

3. Press the Set/Station button ° to store this

setting and proceed to the next step.

4. Set the hour by pressing the Preset Up c

or the Preset Down g buttons.

10