REMOTE CONTROL OPERATION
USING THE REMOTE | BUTTON | FUNCTION |
| ||
|
|
|
| On | Turns on JBL BassQ system |
|
|
|
| Standby | Places unit in Standby |
|
|
|
| BassQ | Runs JBL BassQ calibration |
|
|
|
| Bypass | Bypasses internal DSP |
|
|
|
| Stereo/Mono | Toggles between Stereo and Mono input mode |
|
|
|
| Movie/Music | Toggles between Movie and Music EQ mode |
|
|
|
REMOTE CONTROL BATTERY INSTALLATION
The remote control requires one CR2032 battery. The battery should be replaced as needed. When battery power is low, the remote control enters a
To replace the remote control batteries:
1.Locate the battery compartment on the back of the remote control. Pull down on the battery tray to slide out the old battery. The tray is held in place by a
2.Remove the old battery.
3.Observing the proper polarity, insert one CR2032 battery.
4.Slide the battery tray back into the remote until the tray locks into place.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME (CR2032)
OR EQUIVALENT TYPE.
WARNING:
•DO NOT EXPOSE BATTERIES TO EXCESSIVE HEAT SUCH AS DIRECT SUNLIGHT, FIRE OR THE LIKE.
•DISPOSE OF DEAD BATTERIES IN ACCORDANCE WITH LOCAL REGULATIONS.
7