IF VECHICLE IS EQUIPPED WITH A FACTORY 10 DISC CD CHANGER,
PROCEED TO STEP 16.
13.Align top holes in VCP mounting bracket (item 7 pg 2) with holes in vehicle. See Figure 11.
14.Insert (2) two well nuts (item 2 pg 2) into top holes and secure using (2)
15.Secure bracket to vehicle using (4) four # 10 X 1/2" screws (item 5 pg 2).
FIGURE 12
17. Make all necessary wiring connections to VCP. Check function of VCP. See operating instructions included with components. For further assistance, refer to the video system manual for the technical support phone number listed for your area.
18. Align screws in VCP with slots in bracket and slide into position. Make sure screws are
positioned at bottom of slot. See Figure 13 .
CAUTION: Do not overtighten screws.
FIGURE 11
16. Remove and discard storage pocket (item 10 pg 2). Using a razor knife, carefully trim away plastic flange to allow for CD player. See Figure 12. Make diagonal cuts at the corners to make it easier when breaking tabs.
FIGURE 13
19. Install housing bottom (item 11 pg 2) and carefully fold carpet away from each side to gain access to mounting holes. Secure to VCP mounting bracket using (2) two # 8 X 9/16" screws (item 6 pg 2) on each side. Make sure contour of housing matches floor of vehicle. See Figure 14. Carefully tuck carpet behind O.E. plastic panel.
20. Carefully install housing top (item 9 pg 2) and press
firmly along bottom edge to secure Velcro tape.
FIGURE 14
6
