Jenn-Air 8101P423-60 Installing Bottom Trim Piece, Electrical Connections, Service, Icwrating

When installing a 27" wall oven under a 30" cooktop some interference may occur.The followingcutout

notching of the side trims will eliminate the interference of the side trim to the burner box. After cutting, file the side trim edges to eliminate burrs.

_" _-'-_

f

'

_

CAUTION

For European style cabinets (flush front) the required clearance for operation of the oven door is minimum

spacing of 718" between the cutout and the door, hinge or drawer of the cabinet.

Some built-in cabinets may not be wide enough, dueto their construction, to allow this installation,

1. Cut hole in cabinet to mount oven. Cutout in cabinet should be level and straight,

NOTE: There are no provisions to level the unit after it is installed. An oven that is not level could cause poor baking results,

2. Install plywood floor as shown,

3.Attach unit to the cabinet with four No. 8 x 1" screws supplied with unit inside of envelope containing these instructions. Pre-drill holes in cabinet for attachment

screws using 1/8" drill. Oven mounting holes are provided in side trim.

4.See instructions at right for e_ectficalhook-up.

5, See Use and Care Manual for operating instructions,

Installing Bottom Trim Piece

1.,-

Electrical Connections

Unit to be propedycircuitprotectedand wired according to local electrical code and National Electrical Code.

It is advisable that the electrical wiring and hookup be accomplished by a competent e(ectrician.

120/240 VAC or 120/208 VAC 60 Hz. See serial plate on front of unit for power requirements.

The neutral of this unit is grounded to the frame through

the green or solid grounding wire. (The green and the white wires are twisted together at the termination of the

conduit.) If used on new branch-circuit installations (1996 NEC), mobile homes, recreational vehicles, or in an area where local codes prohibit grounding through the neutral

conductor, untwist or disconnect the green wire and

connect the green wire to ground in accordance with local code. Connect the white neutral to the service neutral.

Connect ail wires to the branch circuit with approved connectors. Use copper or aluminum wire. If aluminum wire is used, use connectors recognized for joining aluminum to copper.

The chart below recommends the minimum circuit

protection and wire size if the appliance is the only unit on

the circuit.

			RECOMMENDEDI IMUM
ICWRATING.			CIRCUITPROTECTION	WIRESIZE
ONSERIALPLATE			INAMPERS	(AWG)
0	-	4.8	20	12
4.9	°	6.9	30	10
7.0-		9.9	40	8
10.0-		1_9	50	8
12.0	-	14.9	60	6

Service

Interruptthe source of electricityto the unitwhen

attempting to repairor servicethe oven. Failureto do this couldresult in a dangerousor even fatal shock.

IMPORTANT - SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE