1.Be sure control knobs are turned off.
2.if the grill burner and grill grates are in place, remove before installing a surface burner module. Clean burner basin of any grease accumulation. (See page 19 for cleaning recommendations.)
3.Position the burner assembly with the mixer tube openings toward the orifices. Slide the burner assembly toward the orifices until opening for igniter is over the igniter.
Lower into place until side openings are resting on the burner supports and igniter is centered between the two flash tubes.
4.Install the aeration tray by inserting the prong at the end of the pan into the opening in the end of the burner basin. Lower the opposite end into the cooktop.
Note: Before first use, read the Surface Burner Grates Care instructions found on p. 19.
1.Control knobs should be in the OFF position and the cooktop should be cool.
2.Remove the aeration tray by lifting up the front end on the right side (back end on the left side) until the top clears the opening of the cooktop by about 5 inches
3.Hold aeration tray by the sides and slide away to remove the prong from the opening and clear the surface burners.
4. Lift up on the sides of the surface burner assembly bracket about 2 inches. Slide away from the orifices.
5.A storage tray, Model AG350, is available and can be used for storing a surface burner module.
NOTE: NOTE:
assembly. Model AG202 air shutters have been adjusted for compatibility on
the left side.
Optional surface burner assembly, Model AG202, can replace the grill burner Do not disassemble the surface burner assembly.
13
