Jenn-Air DW730, DW860, DW710, DW700, DW760 manual

To remove an odor, try one of the following:

1.Place baking soda in both sides of the deter- gent dispenser, Select the Light cycle and let the dishwasher runfor about 20 minutes, Stop

the dishwasher by unlatching the door and let stand overnight. Then, restart the dishwasher by latching the door and let it complete the

cycle.

2.Select the Light cycle and let the dishwasher fill with water. Then open the door and pour 1/4 cup of chlorine bleach into the bottom of

the dishwasher. Latch the door and let the dishwasher complete the cycle. Do not use

detergent.

Clean the control panel and front panel with a soft damp cloth and liquid spray cleaner. Do not use

any abrasive powders or cleaning pads.

CAUTION: To protect against rupture of fill valve, BE SURE the water lines leading to the dish- washer, are well protected against freezing,

1.Run dishwasher through a cycle using deter- gent. If an odor remains, repeat using baking

sodain the dispenser cup or adding 1/4cupof chlorine bleach in the bottom of the tub. Clean

the bottom edge of the door and front lip of the tub with a baking soda and water solution,

2.Turn the water supply off and set the dish- washer to drain (select Rinse & Hold cycle). Once Rinse & Hold is completed, open the door and return Timer to Off.

3.Disconnect the electrical supply,

4.Place a pan under the drain outlet. Disconnect the flexible tubing from the pump and drain the water into pan by pushing down on drain arm lever. Reconnect hose and secure clamp,

5.Prop the door open.

To restore service, turn on the electricity and water supply. Select a wash cycle and let the dishwasher complete the cycle. Check connec- tions to make sure they are water tight,

Your Jenn-Air dishwasher comes with reversible

panel inserts which are pre-assembled at the factory This enables you to select the color you

want before your dishwasher isinstalled orchoose another color at a later date.

To Change Panels

Door Panel

1.Remove three screws holding the side trim

strip on one side of the door. Take note of how the trim comes off.

2.Grasping the lower part of the door panel(s),

bow panel(s) out carefully at the bottom while sliding panel(s) far enough to clear the flange on the trim strip which was not removed and remove panel(s).

3.Arrange panel so the desired color is facing out.

4.Place door panel(s) (notched side up) behind the metal trim at the bottom of the door. Bow

the panels so they fit behind the control panel at the top.

5. Slide the panel(s) under the side metal trim which was not removed. To do this, it will be

necessary to compress the backing behind the colored panel(s).

6.Reinstall the side trim which was removed

earlier. Align the holes and replace the three screws.

Lower Panel - Most Models

1.The lower access panel is held by four screws (two above the panel and two below). With these removed, the panel may be removed to make it easy to change panel colors.

2.With the lower access panel removed, remove the four screws along the bottom of panel and remove the trim which holds the panels. Once the desired panel is facing out, replace the trim, and reinstall the panel to the dishwasher.

Use care when changing panels to be certain you

are not injured on sharp edges and that the panels are not damaged. If you have any questions

concerning changing panels or wish to purchase

a different color panel, contact your local Jenn-Air dealer.

13